Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
public:ai:dsm_installation_calibration [2020/10/11 06:17] europe |
public:ai:dsm_installation_calibration [2021/08/20 08:56] (current) europe ↷ Page moved from ai:dsm_installation_calibration to public:ai:dsm_installation_calibration |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== DSM Installation & Calibration | + | ====== DSM ====== |
| + | |||
| + | {{: | ||
| <note important> | <note important> | ||
| Line 9: | Line 11: | ||
| </ | </ | ||
| - | ==== DSM “Obliquely-facing to the driver” Installation ==== | + | ==== DSM “Obliquely-facing to the driver” Installation |
| 1. Install the camera. DSM camera can be installed obliquely facing the driver if there is not any right place on the dashboard (e.g. it is not flat enough). But the deviation of the angle can’t be bigger than 30 degrees. | 1. Install the camera. DSM camera can be installed obliquely facing the driver if there is not any right place on the dashboard (e.g. it is not flat enough). But the deviation of the angle can’t be bigger than 30 degrees. | ||