Differences

This shows you the differences between two versions of the page.

--- public:ai:dsm_installation_calibration [2020/10/11 06:12]
europe
+++ public:ai:dsm_installation_calibration [2021/08/20 08:56] (current)
europe ↷ Page moved from ai:dsm_installation_calibration to public:ai:dsm_installation_calibration
@@ Line 1: / Line 1: @@
-====== DSM Installation & Calibration ======
+====== DSM ======
+{{:ai:pasted:20201011-064130.png}}
 <note important>
@@ Line 9: / Line 11: @@
 </note>
-==== DSM “Obliquely-facing to the driver” Installation ====
+==== DSM “Obliquely-facing to the driver” Installation & Calibration ====
 . Install the camera. DSM camera can be installed obliquely facing the driver if there is not any right place on the dashboard (e.g. it is not flat enough). But the deviation of the angle can’t be bigger than 30 degrees.
@@ Line 42: / Line 44: @@
 . Sit on the driver's seat and adjust the DSM camera to keep your face on the center of the image. And then wait for the calibration finished. If the calibration is completed, it will display “calibrate_true!” over the image.
-{{:ai:pasted:20201011-061128.png}} {{:ai:pasted:20201011-061147.png}}
+{{:ai:pasted:20201011-061718.png}}
 . Tighten the DSM hex screws and Change DSM channel mode to Normal mode.
@@ Line 50: / Line 52: @@
 <note important>The channel mode must resume to normal mode after calibration. Otherwise, there will be no alerts.</note>
+==== Installation Demonstration ====
+{{:ai:pasted:20201011-061423.png}} {{:ai:pasted:20201011-061509.png}}