Differences

This shows you the differences between two versions of the page.

--- public:ai:bsd_installation_calibration [2020/10/11 06:29]
europe
+++ public:ai:bsd_installation_calibration [2021/08/20 08:55] (current)
europe ↷ Page moved from ai:bsd_installation_calibration to public:ai:bsd_installation_calibration
@@ Line 1: / Line 1: @@
-====== BSD Installation & Calibration ======
+====== BSD ======
+{{:ai:pasted:20201011-064420.png}}
 ==== BSD Installation ====
@@ Line 9: / Line 11: @@
 ==== BSD Calibration ====
   - Place a cone in front of the BSD camera that 2 meters far from the headstock.
-  - Open the IPC settings of the BSD camera channel, e.g. Channel 6.Keep the device as “Calibration” then click ok. But do not secure the camera before finishing the calibration.
+  - Open Liveview page, Click the "AI Calibration" button to enter the next page.
-  - Click the Left & Right arrow button to move the red vertical line.Make the vertical line coincide with the body edge.
+  - Select "BSD" to enter the next page.
-  - Click the Up & Down arrow button to move the yello horizontal line. Make the horizontal line coincide with the cone.
+  - Select "Left BSD" or "Right BSD" to enter the next page.
+  - Select the actual channel to which you connected the BSD camera to calibrate.
+  - Click the Left & Right arrow button to move the red vertical line. Make the vertical line coincide with the body edge.
+  - Click the Up & Down arrow button to move the yellow horizontal line. Make the horizontal line coincide with the cone.
+{{:ai:pasted:20201011-063521.png}}
 {{:ai:pasted:20201011-062502.png}}