Differences

This shows you the differences between two versions of the page.

--- public:ai:bsd_installation_calibration [2020/09/27 12:31]
europe created
+++ public:ai:bsd_installation_calibration [2021/08/20 08:55] (current)
europe ↷ Page moved from ai:bsd_installation_calibration to public:ai:bsd_installation_calibration
@@ Line 1: / Line 1: @@
-====== BSD Installation & Calibration ======
+====== BSD ======
-to be added.
+{{:ai:pasted:20201011-064420.png}}
+==== BSD Installation ====
+  - BSD camera should mount on the side of the vehicle that opposite and lens face forward to the vehicle, 195 ± 15cm high from the ground. (See the red area in the image below)
+  - Check the live view image from the camera calibration and run an alarm test BEFORE securing as it requires a clear and specific image.
+{{:ai:pasted:20201011-062423.png}}
+==== BSD Calibration ====
+  - Place a cone in front of the BSD camera that 2 meters far from the headstock.
+  - Open Liveview page, Click the "AI Calibration" button to enter the next page.
+  - Select "BSD" to enter the next page.
+  - Select "Left BSD" or "Right BSD" to enter the next page.
+  - Select the actual channel to which you connected the BSD camera to calibrate.
+  - Click the Left & Right arrow button to move the red vertical line. Make the vertical line coincide with the body edge.
+  - Click the Up & Down arrow button to move the yellow horizontal line. Make the horizontal line coincide with the cone.
+{{:ai:pasted:20201011-063521.png}}
+{{:ai:pasted:20201011-062502.png}}
+==== BSD Detection Area ====
+The figure below shows a virtual detection area for the BSD system. the area highlight in yellow are the blind sports of the BSD camera itself (4~5 m). The Red area shows the “alarm area” where close to the vehicle, the Green area is the pre-alarm area that system indicate the potential collision.
+{{:ai:pasted:20201011-062539.png}}